Product-specific image.
Eutalloy Powders
What this product is designed to do
Nickel-chromium matrix powder reinforced with tungsten carbide for fine-particle abrasion.
Key product points
- Nickel-chromium matrix powder reinforced with tungsten carbide for fine-particle abrasion. Intended for relatively thin, hard wear-resistant overlays.
Where to use
- Mixer blades, cutter wheels, augers, rock bits, hoppers, chutes and similar parts exposed to fine abrasive material.
Practical checks before the job
- Thermal-spray and spray-and-fuse products require the correct equipment, surface preparation, any specified bond coat, approved spray parameters and post-treatment. This summary is for product selection only—not a process instruction. Confirm the current TDS and qualified operator/process requirements.
This guide supports product discovery and enquiry preparation. It is not a full operating instruction, welding procedure or installation specification. Confirm the exact grade, substrate, operating conditions and latest manufacturer technical and safety data sheets. Follow the approved site procedure and engineering approval where applicable.