Product-specific image.
What this product is designed to do
Casto Cut 160 is listed in the supplied Casto Cut Series brochure as a plasma-cutting equipment model with a 160 A current rating at 60% duty cycle. Contact Darius to confirm suitability, current availability and technical documentation.
Product details
- Input supply: 353–478 VAC, 3-phase, 50/60 Hz (as stated in the supplied brochure).
- Current at 60% duty cycle: 160 A.
- Current at 100% duty cycle: 124 A.
- Rated output voltage: 144 V; open-circuit voltage: 380 V.
- Protection class: IP21; digital voltage/current display; Class H insulation; forced-air cooling; 85% efficiency (brochure data).
- Fine cutting thickness: 28 mm; coarse cutting thickness: 40 mm (brochure terminology).
- Dimensions (L × W × H): 600 × 370 × 660 mm; weight: 67 kg.
- Earth and welding cable connection: Euro connector (as listed in the supplied brochure).
Key product points
- Heavy-duty, rugged equipment described in the supplied Casto Cut Series brochure.
- Digital display, forced-air cooling and Class H insulation are listed in the supplied brochure.
- Select the model against material type, thickness, duty cycle, supply characteristics and approved operating instructions.
Where to use
- Workshop and fabrication cutting of compatible electrically conductive metal plate and components.
- Project sites where a suitable three-phase electrical supply and compressed-air/cutting set-up are available; confirm the installation requirements with Darius.
Practical checks before the job
- Confirm the metal type, plate thickness, cutting quality requirement and job volume before selecting the model.
- Verify that the site electrical supply matches the machine nameplate and the supplied technical documentation.
- Confirm cutting air supply, torch, consumables, protective equipment and work-area ventilation requirements from the current manufacturer manual.
- Set cutting parameters for the material and thickness using the model-specific operating manual; do not copy settings from another model.
- Inspect the cut edge and consumables, isolate power before service and follow the manufacturer maintenance instructions.
Selection check: This product is plasma cutting equipment, not an arc welding power source. Confirm current availability, model revision, input characteristics, air requirements and cutting limits with Darius before purchase.
This guide supports product discovery and enquiry preparation. It is not a full operating instruction, welding procedure or installation specification. Confirm the exact grade, substrate, operating conditions and latest manufacturer technical and safety data sheets. Follow the approved site procedure and engineering approval where applicable.